Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Exterior Section: Sliding Roof/Convertible
Model Year: 2008 Model: Sequoia Doc ID: RM000002LPB00AX
Title: SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REMOVAL (2008 Sequoia)

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .

2. REMOVE ROOF HEADLINING ASSEMBLY

(a) Remove the roof headlining INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia) .

3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

(a) Remove the curtain shield airbag SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL (2008 Sequoia)+ .

4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

HINT:

Use the same procedure for the RH side and LH side.

5. REMOVE SLIDING ROOF SIDE GARNISH RH

(a) Disengage the 2 claws and the 3 guides, and remove the side garnish.

6. REMOVE SLIDING ROOF SIDE GARNISH LH

HINT:

Use the same procedure for the RH side and LH side.

7. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY



(a) Using a "TORX" socket wrench T25, remove the 4 bolts and glass.

8. REMOVE SLIDING ROOF WEATHERSTRIP

(a) Remove the sliding roof weatherstrip.

9. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY

(a) Disconnect the 4 sliding roof drain hoses.

(b) Remove the 10 bolts, 6 nuts and housing.